ESP32-C61-DevKitC-1-N8R2
Demand rank: ESP32 family is rank 1 in the JetBrains State of Embedded 2025 MCU survey (38%). The survey does not report a C61-specific percentage. The current C61 variant is listed in Espressif's live board guide and catalog; see the live board and BME280 availability receipt.
| Artifact | Path |
|---|---|
| Chip descriptor | configs/chips/esp32c61.yaml |
| Board system | configs/systems/esp32c61-devkitc-1-n8r2.yaml |
| Firmware and smokes | examples/esp32c61-devkitc-1-n8r2 |
Pin map and profile
| Board pin | SoC signal | LabWired profile |
|---|---|---|
| J3 TX | UART0 TX, GPIO11 | UART0 FIFO and PCR clock gate are modeled; pad routing is not |
| J3 RX | UART0 RX, GPIO10 | UART0 receive and pad routing are not modeled |
| J1 pin 3 | GPIO4 | Output latch and enable register are modeled; IO_MUX and electrical behavior are not |
| J1 pin 5 | GPIO6 | I2C0 SDA for the BME280 smoke; GPIO matrix route is modeled |
| J3 pin 6 | GPIO22 | I2C0 SCL for the BME280 smoke; GPIO matrix route is modeled |
| J1 pin 9 | GPIO8, addressable RGB LED | GPIO output and WS2812 decode are checked by the BME280 board smoke |
The GPIO output smoke checks bit 4 in GPIO_OUT_REG and GPIO_ENABLE_REG after
firmware sets GPIO4. The BME280 smoke configures GPIO6/GPIO22 for I2C0 and reads
the device ID (0x60) plus a deterministic raw-temperature test vector. It
then bit-bangs a red WS2812 frame on GPIO8 and requires the attached NeoPixel
model to decode one lit pixel. The GPIO model covers the C61 I2C0 matrix
selectors and direct output path; it does not cover other peripheral matrix
routes, GPIO26..29, GPIO interrupts, or electrical pad behavior. IO_MUX values
are stored but not enforced. GPIO8 strap sampling during reset and the RMT
peripheral are outside scope.
The board profile fast-loads a bare ELF directly; it does not execute the mask-ROM boot path or Espressif bootloader. The UART test captures FIFO output in the host console but does not model the physical USB-to-UART bridge.
GPIO copy-paste example
const GPIO_OUT_W1TS: *mut u32 = 0x6009_1008 as *mut u32;
const GPIO_ENABLE_W1TS: *mut u32 = 0x6009_1038 as *mut u32;
const GPIO4: u32 = 1 << 4;
unsafe {
core::ptr::write_volatile(GPIO_ENABLE_W1TS, GPIO4);
core::ptr::write_volatile(GPIO_OUT_W1TS, GPIO4);
}
The full firmware and build/test commands are in
examples/esp32c61-devkitc-1-n8r2.
The GPIO smoke expects bits 4 in GPIO_OUT_REG and GPIO_ENABLE_REG; the UART
smoke expects C61_N8R2_OK. Logs and structured results are under the example's
evidence/ directory.
The BME280 wiring, copy-paste ESP-IDF example, GPIO8 LED smoke, fresh smoke,
scope, and live availability receipt are documented in
examples/esp32c61-devkitc-1-n8r2-bme280.