Skip to content

STM32L432KC / NUCLEO-L432KC

Support: raw-register firmware smoke (PR-gated) plus the stock STM32duino Arduino matrix row L0-L8; simulated, not hardware-validated.

  • 256 KiB flash, 64 KiB SRAM, Cortex-M4F, maximum 80 MHz, UFQFPN32.
  • Model: configs/chips/stm32l432kc.yaml; board: configs/systems/nucleo-l432kc.yaml.
  • Instance set from ST's stm32l432xx.h (RM0394 L43x), not the L476: USART1, USART2, LPUART1, SPI1, SPI3, I2C1, I2C3, one ADC, TIM1/2/6/7/15/16, LPTIM1/2, bxCAN1, DAC, DMA1/2, GPIOA/B/C/H. Register behaviour reuses the STM32L4 family models.
  • PR-gated smoke: Cortex-M reset/stack, RCC enables, USART2 output on PA2, GPIO PB3 (LD3) edges.
  • Stock STM32duino NUCLEO_L432KC (MSI PLL 80 MHz + LSE): Serial, delay, LD3 blink, Wire INA219 exact register reads, SPI MAX31855 exact frame, analogRead(A0) at a board-held 1650 mV, analogWrite on LD3 (TIM2_CH2, 1 kHz), micros(), bxCAN1 loopback. Evidence: examples/nucleo-l432kc/evidence/arduino-matrix/.
  • Absent: USB FS device, CRS, OPAMP, SWPMI and FIREWALL are not declared, so an access faults instead of reading zeros. SYSCFG is a read-zero stub.
  • Not proven: no silicon register diff, no reset-value capture, REV_ID is a placeholder 0.

Build / run and validation receipt. ST product page.