Skip to content

CC2538 IOC stub negative control (2026-11-07)

Same firmware (firmware-cc2538dk-smoke, with ioc_selftest) and the same examples/renode-onboarding/cc2538-smoke.yaml assertions, run against the pre-change configs/chips/cc2538sf53.yaml, where ioc was type: stub.

Result: FAIL 2/3 checks (uart_ordered fails). The stub answers every IOC read with zero, so the read-back line is

ioc pa1_sel=00 pa1_over=00 pa0_over=00 rx0=00 pd7_over=00 gpt3ocp2=00 restored=00

instead of the cc2538_ioc model's

ioc pa1_sel=00 pa1_over=08 pa0_over=00 rx0=00 pd7_over=04 gpt3ocp2=1f restored=00

(PA1_OVER written 0x8, PD7_OVER at its Table 9-7 reset 0x4, an all-ones IOC_GPT3OCP2 write kept to INPUT_SEL[4:0]). uart.log and result.json here are that run's output. This is a model-only CLI result, not a hardware capture.