Skip to content

Negative control — EFM32ZG222 without the Series-0 GPIO ports and TIMERs

Same firmware (firmware-efm32zg222-smoke, shared s0.rs checks over USART1) and smoke assertions, against a temporary copy of the pre-round-383 configs/chips/onboarding/efm32zg222.yaml (USART1 only, no efm32s0_gpioport / efm32s0_timer entries).

Result: FAIL 2/5. The firmware prints its banner, then faults at 0x40006050 (GPIO port C MODEH) on its first GPIO access. The uart_ordered, gpio_edges (gpioc:10) and memory_value (0x20000F00) assertions all fail, so the smoke passes only because of the new descriptor entries.

Note: the fault report prints CFSR/BFAR even though this is a Cortex-M0+ (ARMv6-M has no configurable fault status registers; silicon just takes HardFault). The engine's diagnostic, not the firmware's view.