Skip to content

PLIC smoke fixture failure: stale final GPIO readback

This retained run is a reproduced fixture assertion failure, not a platform boot failure. The pre-fix firmware configures GPIO_0 port 0 to raise the PLIC source, then checks the old all-high input value after it has cleared the GPIO output latch. At that point only port 0 is high, so the result correctly reports 0x1 instead of the stale expected 0x3fff.

The final smoke disables interrupt generation, restores CFG_ALL = 0x7 and GPIO_OUT = 0xffffffff, then checks the 14-port input value. The current per-target metrics pass 9/9 assertions for all three imported systems. This archive is kept for the failed attempt history and is not part of active scoreboard metrics.