Negative control: SPIM3 hardware CSN not honoured by the fast SPIM model
Same firmware (firmware-nrf52840-renode-smoke with check_spim3_hw_csn),
same chip and system descriptors (SPIM3 at 0x4002F000, MAX31855 fixture with
cs_pin: P0.20). In crates/core/src/peripherals/spi.rs the nRF52 SPIM3 arm
of do_nrf52_easydma was disabled (if false && self.nrf52_hw_select), which
is the pre-fix behaviour: PSEL.CSN selected devices on the nRF54L map only.
CLI rebuilt.
Result: FAIL 5/7. UART:
spim3 csn max31855=00000000/00000000 n=8 gpio=1 irq47=1 FAIL,
NRF52840 FAIL summary=0ffff (bit 16 clear). The transfer completes and
pends line 47, but the fixture is never selected (P0.20's GPIO latch is high),
so MISO is 0. With the fix: max31855=01901600/01901600.
A third state was seen during development but not kept as an artifact: with
the CSN fix and without the EasyDMA on_event IRQ pend, the same line read
irq47=0 FAIL.